A/C SYSTEM FLUSH GUN KIT

Item No:
AMC013R-A

CAPACITY:
90-150 PSI

Packing:
PLAIN BOX + SHRINK
6PC/13.00/14.00/1.40'/CTN

INSTRUCTION:

• Recover refrigerant from air conditioning system in accordance with local, state and federal laws.

• Disconnect all hoses from the components in the system. Isolate the components to flush.

• Remove and discard orifice tube from evaporator, condenser or hose or remove expansion valve.

• Attach the flush hose to the batten fitting on the flush cylinder. Attach the flush gun to hose.

• Fill the flush cylinder w/ 1~2 pints of flush solvent. Lubricate the O-ring seal and threads on the large nut and screw the nut onto top of the cylinder. Make sure all connections are tight.

• To avoid spraying of oil, flush and other debris, attach a piece of hose or optional flush capturing coupler to the end of the component being flushed. Place the hose end in a large bucket to capture the flush solvent.

• Attach your compressed air hose to the large nut on the top of the cylinder. Hold flush cylinder in an upright position. Flushing will work effectively with air pressure of 90-150 PSI

• Insert the probe end of the flush gun into end of component and press the flush gun lever.

• Flush the component until all the flush solvent has passed through it. Wait 3 minutes and run dry air through the component again. Disconnect the air supply to the flush cylinder when not actually flushing

• Evacuate for 30 minutes and make sure the system holds a vacuum.

Related Products: