COOLING SYSTEM VACUUM PURGE & REFILL KIT

Item No:
AMR2000E

Packing:
BLOW CASE
10 SET/ 15KGS/ 16.5KGS/ 3.05'/ CTN

Directions:

• Please empty water of radiator. Choose a suitable rubber bush, and place it between cooling system adaptor and radiator tightly

• Connect cooling system adaptor to vacuum pump, and connect shop air to air connector, then turn on the wsltch

• Allow air pressure to reach a vacuum level approximately between 20~25 inHG (50~60cmHG) of mercury. Please turn off the switch, and take off the vacuum pump

• Connect coolant hose to cooling system adaptor and then turn on the switch. (The coolant hose should have filled with coolant, and put in the container which filled with coolant) After minutes, the coolant will flow to the radiator via coolant hose until the needle points zero

• When you finish all the work, check if the radiator is fully filled with coolant or not. If it is not, please fill the coolant yourself until radiator is full of coolant